![]() Reason 2: HDD MalfunctionĪ year ago, while I was using my PC to finish some of my delayed tasks, my pc goes down suddenly! If you are still experiencing power supply-related issues, you may need to replace the power adapter or cable as I did. So, when you use the wrong power adapter, you’ll probably get your device rebooted multiple times.Īnyway, To troubleshoot this issue, check the info printed sticker/label on the recorder to ensure that you are using the correct power adapter and that it is providing enough power for your recorder.Īlso, you should check the input voltage to ensure that it is stable and not too low. These cameras are powered by a 5v DC power adapter while NVR/DVR uses much voltage 12v DC. In some cases, the camera owners forget and use the power adapter of analog CCTV cameras or IP cams. Most available NVRs/DVRs are powered by a 12vDC adapter. ![]() The moment when this issue repeated with my video recorder unit and I noticed that the unit shut down automatically, I ran and checked the power adapter of the video recorder. I faced this issue before but with my home network router, I struggle for days until I figured out that the problem was in the power adapter. The first and considered main issue for device rebooting is the insufficient power supply or unstable. Plus, we’ll also give you the solutions for each case. In the below words, we mention each reason separately. Not only that but there are hidden reasons that cause DVR or NVR to keep rebooting. when someone damages surveillance system wires by intention, or when the video recorder unit falls hard on the ground or is thrown on the tough floor. The bad news, this issue is not common, and it happens in rare cases. If you’re a beginner or have limited knowledge of security cameras, you may suffer for a long time to find a proper solution for your problem. Now, Why Does My DVR or NVR Keep Rebooting Itself? Reasons and Solutions What I mean by system wiring is power wires that have been used for turning on the cameras and video recorder, and also signal cables like coaxial or ethernet cables that might be damaged or cut over time. These elements can be the main reason for NVR or DVR rebooting issues. However, there are other potential causes such as old wiring or loose connectors. Well, the most common reason that makes DVR or NVR reboot regularly is an insufficient power supply, hardware problems especially the HDD of the video recorder, and other reasons such as network configuration, old firmware, overheating, and finally rebooting settings. What are the common reasons for DVR or NVR Rebooting? or What causes DVR to reboot?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |